Install instructions:

1. Turn off the switch,unfold the engine after the car cool,remove the same type of bulbs in the discharge light group to take the place of the original halogen bulbs and then plug all cables attached into the sockets and ballast related.Mustn't touch the surface of HID bulb with hands.If it is dirty,it should be cleaned with the rag;

2. Changing the fuse in the circuit of the car into the fuse special for HID;

3. Before installation,check whether the bulb can touch the inner cover of the light or the opening is too small.If so,install after proper adjustment.

4. Put the bulb into the light cover carefully with no damaging force,and then stabilize it and put the waterproof ring to the original.

5. After installation is over,connect the bulb with the ballast.

6. Fix the ballast in the proper lace (careful for 3M double-face glue is very sticky);

7. Connect high-voltage line with the bulb.Connect the input line of the ballast with the socket of the light, and make the ballast firmed.(Keep in mind:Must be far away from high temperature and the place is in bad heat dispel) The former factory car light HID all put under the headlight;

8. Check whether the bulb is fixed the cables between the bulb and the ballast is fastened.

9. Plug the cable from the voltage ballast into the engine.

10. Please pay attention to keep the space with the ballast.Don't approach the following positions;otherwise HID light will be overheated so as to go out:
（A）The Mars is filled in and filled with the Mars in the circuit.
（B）Circuit of the electronic carburetor.
（C）Water tank, and the high temperature of engine.
（D）Choose the position that ventilate and dispel the heat better.
（E）Avoid the position that water accumulated, leaked.

11. Please confirm whether the length and width of light will touch lens hood and enter of lamp (Model H7 light please attention to the length, Model H1 light should be pay attention to width) If it is contacted, repair it properly avoid the high-tension electricity from leaking;

12. Turn on the power supply,test the lights; turn off the power supply,clear the cables;retest once, then turn on the headlight.